Permitted Use; Residual Risks - Checchi & Magli SP onion-Serie Bedienungs- Und Wartungsanleitung

A) Hazard plate: risk of entanglement, dragging, and
crushing of the upper limbs with the rod conveyor.
B) Hazard plate: switch off the tractor; remove the igni-
tion key and store in a safe place before carrying out
any type of work on the work vehicle.
C) Hazard plate: read the use and maintenance manual
before using the work vehicle.
D) Information plate: lubricate the chain inside the
casing to which the plate is affixed.

Permitted use

The machine is designed to dig up tuberous crops and
place them on the ground.
The machine must be used in conformity with its techni-
cal characteristics; it is forbidden to make modifications
Improper and unauthorised uses
Use of the work vehicle is forbidden in the presence of
an explosive or flammable atmosphere.
Use of the work vehicle to carry persons is forbidden.
Use of the work vehicle with incompatible tractors is for-
bidden (see "Technical characteristics").

Residual risks

During the design and construction stages, the manufac-
turer has focused particular attention on safety aspects;
nevertheless the risks described below remain.
Crushing hazard: when handling the work vehicle, in-
correct manoeuvres and mishandling of the load may
cause injury to the persons involved in the procedure.
English language
TECHNICAL INFORMATION
E) Information plate: shows the hook up points.
F) Hazard plate: make sure the rotation direction and
the tractor PTO rpm complies with the specifications
on the plate.
G) Information plate: this indicates rotation of the part
to which the plate is applied, showing the direction
required to achieve the desired effect.
H) Information plate: this shows the greasing points.
or use the machine for improper uses.
Any other use is considered improper and therefore it is
not authorised.
Use of the work vehicle is forbidden if any device has
been tampered with in order to achieve different per-
formance to that envisaged.
Use of the work vehicle is forbidden if any guards are
either damaged or missing.
Entanglement, dragging, and crushing hazard: dur-
ing operation, accidental contact with the rod track may
cause injury.
Cutting risk: accidental contact with the edges of the
cutting disc can cause cuts or puncture wounds.
Crushing and trapping hazard: the procedures for
hitching up and uncoupling the work vehicle to and from
the tractor may cause injury to the persons involved.
6
2
Use and maintenance