Checchi & Magli SP onion-Serie Bedienungs- Und Wartungsanleitung Seite 56

Check of nuts and bolts tightening torque
Check the tightening torque of all nuts and bolts.
If the bolts are loose tighten them to the prescribed
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
Troubleshooting
The following list contains a number of common prob-
lems that may arise during work, together with the ways
Problem
Accumulation of weeds
and foliage around the
digging shaft
Too much earth on the
rod conveyor
The crop unloaded has a
great deal of earth with it
Crop is damaged
English language
MAINTENANCE INFORMATION
Likely cause
The wheels with cutting discs
are not resting on the ground
properly
Digging shaft is digging too
deeply
Rod conveyor speed is too low
Digging shaft is digging too
deeply
The shaker has not been
switched on
Digging shaft is not digging
deeply enough
Rod conveyor vibration too great Reduce rod conveyor vibration
Rod conveyor speed is too high
torque (see the "Nuts and bolts tightening torques
chart").
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication points diagram").
to solve them.
Solution
Lower the work vehicle onto
the ground
Decrease the depth of the
digging shaft in the ground
Increase PTO rotation speed
Decrease the depth of the
digging shaft in the ground
Switch on the shaker
Increase the depth of the
digging shaft in the ground
Reduce PTO rotation speed
22
7
Reference
See "Adjusting wheels with
cutting disc"
See "Adjusting wheels with
cutting disc"
See "Activating the shaker"
See "Adjusting wheels with
cutting disc"
See "Activating the shaker"
Use and maintenance