Checchi & Magli SP onion-Serie Bedienungs- Und Wartungsanleitung Seite 50

UN41-0827LR
Carry out the operations described.
1)
Start moving the tractor to move the three-point
hitch on the frame closer.
2)
Align the arms of the lifting unit with the coupling
points on the work vehicle.
3)
Switch off the tractor engine, remove the ignition
key, and store in a safe place.
4)
Turn the tie rods (A) to adjust the height of the lift
Fitting the driveshaft
The manufacturer recommends that the drive shaft/
clutch assembly (supplied as an accessory) be fitted.
DANGER
Always fit the drive shaft with the engine off and the
ignition key removed and safely stored away.
To maintain the drive shaft mounting direction, fit it
on the tractor on the side shown by the symbol (see
the instruction manual provided by the driveshaft
manufacturer).
Check that the driveshaft is properly secured to the
PTO and the splined shaft on the gearbox.
Check that the PTO rotation speed and direction
comply with the machine specifications (see "Techni-
cal characteristics").
Check that the guards are in perfect condition and
properly mounted.
English language
INFORMATION FOR USE
E
A
G
arms (B) (see tractor instruction manual).
5) Insert the pins (C) into the lift arms and fit in the lock
pins (D).
6) Rotate the link pin (E) to adjust the distance be-
tween the tie rod and the upper coupling (F) on the
frame.
7) Slide in the pin (G) and secure with the lock pin (H).
UN47-0751CP
Carry out the operations described.
1)
Check the driveshaft length can offset the machine's
movements in any working manoeuvre (steering,
gradients, etc.).
16
H
F
B
D
C
A
A
Use and maintenance
6