Honeywell Miller HANDZUP Anwendungshinweise Seite 10

As specified in the EN 363 «Fall Arrest Systems» standard, the work positioning
lanyard is a system providing support in the workplace. This allows the user to
work supported or suspended by preventing free fall.
In workplace support systems, the user normally relies on his equipment to
support him. It is therefore essential to take particular account of the need for a
backup, such as a fall arrest system or collective protection equipment (e.g. safety
nets, airbags). Before each use, ensure there is sufficient fall clearance beneath
the user to prevent a collision with the floor or any obstructions. See figure 1.
It must only be used with a fall arrest harness compliant with the EN 361 stand-
ard, as part of a fall arrest system. See figure 2.
The anchoring device must comply with the EN 795 standard. Connectors must
comply with the EN 362 standard (see Appendix 2).
IF THE PRODUCT IS SOLD OUTSIDE THE FIRST COUNTRY OF
DESTINATION, FOR THE SAFETY OF THE USER, THE DEALER
MUST ENSURE THAT THE PRODUCT IS COMPLIANT WITH
THE LAWS APPLICABLE IN THAT COUNTRY AND PROVIDE
INSTRUCTIONS FOR THE PRODUCT IN THE APPROPRIATE
LANGUAGE, COVERING ALL THE REQUIREMENTS OF THE EN
2 - TRAINING
The use of our products is restricted to competent persons having undergone
appropriate training (provided by an authorised person or organisation) or under
the supervision of a competent superior.
The completion of this training must be recorded by the issue of a course cer-
tificate showing the date, location, name and company of the trainer or training
organisation, the full name of the user, etc.
Make yourself familiar with this PPE and ensure you have fully understood how it
works (see paragraph 5).
Anyone performing work at height should be in good physical condition. Certain
medical conditions (medication, cardiovascular condition, etc.) may impair the
safety of the user during normal use of the PPE. If in doubt, check with your doc-
tor.
3 - COMPLIANCE WITH THE EUROPEAN STANDARD EN 358:2018
The lanyard (compliant with EN 358) should be used with a harness belt or safety
belt also compliant with the EN 358 standard.
The lanyard should not be used to stop falls. It may be necessary to supplement
support systems with collective or individual fall arrest systems (fall arrest sys-
tems compliant with EN 363). See figure 3.
4 - VERIFICATION
If your product is damaged, please consult the manufacturer or its representa-
tive. If you have any doubts regarding the safety of a product or if the product has
been used to arrest a fall, it is essential for your safety that the PPE be withdrawn
from service and returned to the manufacturer or an authorised service centre for
inspection or disposal.
Before further use of this PPE, it is your responsibility to obtain a written certifi-
cate from your repairer authorising you to resume using the product. Any modi-
10
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
DO NOT INTERFERE WITH ONE ANOTHER.
358 STANDARD AND APPLICABLE LAW.