Fixture Dh40Bv; First Commissioning; 3.10.1 Power Supply - Optimum OPTIdrill DH 28BV Betriebsanleitung

3.9

Fixture DH40BV

Img.3-4: Marking of the fixing points on the DH40BV
3.10

First commissioning

ATTENTION!
Before commissioning the machine, check all screws, fixtures and/or safety devices and
tighten up the screws if necessary!
WARNING!
Risk by using improper tool holders or operating them at inadmissible speeds.
Only use the tool holders (e.g. drill chuck) which were delivered with the machine or
which are offered as optional equipment by OPTIMUM.
Only use tool holders in the intended admissible speed range.
Tool holders may only be modified in compliance with the recommendation of OPTI-
MUM or of the manufacturer of the clamping devices.
WARNING!
When first commissioning the drilling machine by inexperienced personnel you
endanger people, the machine and the equipment.
We do not accept any liability for damages caused by incorrectly performed
commissioning.

„Qualification of personnel" auf Seite 71

3.10.1 Power supply

CAUTION!
Lay the connection cable of the machine so that a stumble of persons is prevented.
GB
DH24BV | DH28BV | DH34BV | DH40BV
90 Originalbetriebsanleitung
2x
Version 1.1.4 - 2022-09-14