Teds Transducer Identification - HBM S9M Montageanleitung

9

TEDS TRANSDUCER IDENTIFICATION

TEDS (Transducer Electronic Data Sheet) allows you to store the sensor characteristic
values in a chip as per the IEEE 1451.4 standard. The S9M can be delivered with TEDS,
which is then fitted in the transducer housing, connected and supplied with data by HBM
before delivery. If the force transducer is ordered without calibration, the characteristic
values from the manufacturing certificate are stored in the TEDS chip. If an additional
DKD calibration is ordered, the calibration results are stored in the TEDS chip.
The TEDS module is connected between PIN E (sense lead (-)) and PIN D (excitation volt­
age lead (-)). HBM's zero wire configuration allows the TEDS to be read without an addi­
tional sense lead.
If a suitable amplifier is connected (e.g. QuantumX from HBM), then the amplifier elec­
tronics will read the TEDS chip and parameterization will follow automatically, without
any intervention required by the user.
The chip content can be edited and modified with suitable hardware and software. This
can be implemented, e.g. with the Quantum Assistant or also with the CATMAN DAQ soft­
ware from HBM. Please follow the operating manuals of these products.
S9M
25
TEDS TRANSDUCER IDENTIFICATION