mectron starlight pro Gebrauchs- Und Wartungsanleitung Seite 30

starlight pro
10
the Table 5 at page 25.
The charging unit does not
switch on (none of the LEDs
light up).
The yellow battery LED
(check) of the charging unit
The yellow battery LED
(check) of the charging unit
There is no light emission
the starlight pro is pressed
and an acoustic signal is
produced (2 beeps).
An acoustic signal is
produced at the end of the
An acoustic signal (3
beeps) is produced during
at the end of the cycle
starlight pro will not allow
any further treatment to be
carried out.
The polymerisation is
24
The power cable is not
correctly connected.
The power cable is faulty.
The charging unit is out of
order.
The contacts of the charging
unit have been short-
circuited.
Battery failed.
Battery discharged.
Battery low.
The thermal protection has
been activated.
The terminal surface of the
soiled.
Connect the cable both to
the charging unit and to the
wall socket.
Replace the power cable.
Contact an authorised
assistance centre.
See
Contact Mectron Customer
Service. See
Recharge the battery. See
Recharge the battery. See
It will be possible to use the
equipment only after it has
cooled down. See
See