Light Intensity Measurement - Mectron Starlight Pro Gebrauchs- Und Wartungsanleitung

starlight pro
6.4
1.
intensity sensor without pressing it (Figure 8 at page 18 - Ref. B);
2.
The test LED (Figure 8 at page 18 - Ref. D) will indicate the measured light-intensity:
•
•
on the patient and carry out the following checks:
1.
2.
).
3.
disconnecting it from the mains) and make sure that it cannot be started by unauthorised
persons. Any repair work on the device should be carried out by an authorised Mectron service
centre.
18
C

Light Intensity Measurement

A
B
D