Setting The Groove Depth; Vacuuming; Operation - Parkside PMNF 1500 A1 Originalbetriebsanleitung

Setting the groove depth

1.­ Release­the­retaining­screw­(17).
2.­ Set­the­scale­on­the­protective­cover­(5)­
to the required depth.
3.­ Reattach­the­protective­guard­(5)­with­
the­retaining­screw­(17).

Vacuuming

During operation, the wall chaser gener-
ates a large quantity of dust. You should
therefore wear a dust mask, and always
connect an industrial vacuum cleaner.
If the vacuum system malfunctions, pause
operation and clear the malfunction!
Attaching the vacuum cleaner
Unscrew­the­suction­connector­(9)­cap.­
Insert the industrial vacuum cleaner's hose
through the cap and screw the cap tight.
If your vacuum cleaner's hose is the wrong
diameter for a direct connection, you can
insert­the­vacuum­adapter­(10)­in­between­
with a single turn.
Always attach a vacuum cleaner. Damage to
the motor caused by failure to attach a vacu-
um cleaner is not covered by the warranty.

Operation

Caution!
Risk of injury!
-­ Always­remove­the­mains­plug­before­
working on the tool.
-­ Only­use­diamond­cutting­discs­and­
accessories recommended by the ma-
nufacturer. Using other attachment tools
and other accessories can represent a
risk of injury for you.
-­ Only­use­grinding­tools­which­bear­in-
formation about the manufacturer, type
of binding, dimension and permitted
number of revolutions.
-­ Only­use­grinding­discs­where­the­
printed rotational speed is at least as
high­as­what­has­been­specified­on­the­
name plate of the device.
-­ -Do­not­use­any­broken,­cracked­or­
otherwise damaged diamond cutting
discs
-­ Never­operate­the­device­without­
protective equipment.
- Support the plates or workpieces in or-
der to reduce the risk of kickback from
a jammed cutting disc. Large workpiec-
es may bend under their own weight.
The workpiece must be supported on
both sides of the disc, not only near the
cutting disc, but also at the edge.
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
Switch the device off and remove
the mains plug. Allow the device to
cool down.
Notes on statics:
Slots­in­load-bearing­walls­are­subject­to­
the­standard­DIN­1053­Part­1­or­country-
specific­specifications.­These­rules­must­be­
strictly adhered to. Before starting work,
consult the responsible structural engineer,
architect or the responsible construction
management.
GB IE
35