Parkside PMNF 1500 A1 Originalbetriebsanleitung Seite 29

f) Dress properly. Do not
wear loose clothing or
jewellery. Keep your hair,
clothing and gloves away
from moving parts. Loose
clothes, jewellery or long hair
can be caught in moving parts.
g) If devices are provided
for the connection of dust
extraction and collection
facilities, ensure these are
connected and properly
used. Use of dust collection can
reduce­dust-related­hazards.­
4) Power tool use and care :
a) Do not force the power
tool. Use the correct pow-
er tool for your applica-
tion. The correct power tool
will do the job better and safer
at the rate for which it was de-
signed.
b) Do not use the power tool
if the switch does not turn
it on and off. Any power tool
that cannot be controlled with
the switch is dangerous and
must be repaired.
c) Disconnect the plug from
the power source and/or
the battery pack from the
power tool before making
any adjust -ments, chang-
ing accessories, or storing
power tools. Such preventive
safety measures reduce the risk
of starting the power tool acci-
dentaIly.
d) Store idle power tools out
of the reach of children
and do not allow persons
unfamiliar with the power
tool or these instructions
to operate the power tool.
Power tools are dangerous in
the hands of untrained users.
e) Maintain power tools.
Check for misalignment
or binding of moving
parts, breakage of parts
and any other condition
that may affect the power
tool's operation. If dam-
aged, have the power tool
repaired before use.­Many­
accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp
and clean. Properly main-
tained cutting tools with sharp
cutting edges are less Iikely to
bind and are easier to control.
g) Use the power tool, ac-
cessories and tool bits etc.
in accordance with these
instructions, taking into
account the working con-
ditions and the work to be
performed. Use of the power
tool for operations different from
those intended could result in a
hazardous situation.
5) Service:
a) Have your power tool ser-
viced by a qualified repair
person using only identi-
cal replacement parts. This
will ensure that the safety of the
power tool is maintained.
GB IE
29