GB
IE
Cutting disc (included):
Idling speed n
............. max.12250 min
0
Disc speed ....................... max. 80 m/s*
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22,23 mm
*
The grinding disc must keep a rotational
speed of 80 m/s.
Levels of noise and vibration were deter-
mined according to the norms and regula-
tions in the declaration of conformity.
The vibration emission value has been
measured according to a standardised test-
ing method and may be used for compari-
son with another electric tool.
The indicated vibration emission value may
also be used for an introductory assess-
ment of the exposure.
Warning:
The vibration emission value whilst
actually using the electrical tool
may vary from the given values in-
dependently of the type and way in
which the electric tool is used.
Try to keep the exposure to vibra-
tionsaslowaspossible.Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
butrunningwithoutanyload).
26
Notes on safety
-1
Caution! When using power
tools, observe the following
basic safety measures for the
prevention of electric shocks
and the risk of injury and
fire.
Please read all these instruc-
tions before using this electric
tool and please keep the
safety instructions.
Symbols and icons
Symbols on the device:
Warning!
Warning!Electricshockhaz-
ard.
Always unplug the device
before working on it.
Read the manual!
Wear eye and ear protec-
tion.
Wear breathing protection.
Risk of cuts!
Wearcut-resistantgloves.
Wear safety shoes.
Do not use for wet grinding.
Working direction