Connecting The Sawdust Extraction Device; Operation; Switching On And Off; Setting The Cutting Angle - Parkside PHKSA 18-Li B2 Originalbetriebsanleitung

Fig. B: Cutting width 3 cm
♦ Retighten the wing screw
Connecting the sawdust extraction
device
♦ Attach the dust extraction adapter
ejector .
Optional depending on the diameter of the dust
and sawdust extractor.
♦ Connect an approved dust and chip extraction
device.

Operation

Switching on and off
Switching on:
♦ Push the safety lock-out
and keep it pressed.
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off:
♦ Release the ON/OFF switch

Setting the cutting angle

You can select the cutting angle using the cutting
angle scale .
■ Release the wing screw
preselector, set the desired cutting angle on the
cutting angle scale
wing screw .

Setting the cutting depth

NOTE
► Select a cutting depth of approx. 3 mm more
than the thickness of the material. This ensures
that you achieve a clean cut.
♦ Release the locking screw
cutting depth on the cutting depth scale
then retighten the locking screw
PHKSA 18-Li B2
.
to the chip
to the left or right
. Once the saw is
.
on the cutting angle
and then retighten the
, set the desired
and
.

Working with the circular saw

1. Switch on the appliance – as described in
"Switching on and off" – and then place it with the
front edge of the base plate
2. Align the machine using the guide fence
by using a marked line.
3. Hold the machine in both hands using the handles
and saw by exerting an even pressure.
Switching the laser on and off
Switching on:
♦ Press the laser ON/OFF/RESET switch
Switching off:
♦ Press the laser ON/OFF/RESET switch
NOTE
► OVERLOAD AND RESET! The appliance
switches off in case of overload operation.
♦ Switch OFF the laser. Press the laser ON/
OFF/RESET switch
► An automatic reset is only possible once the
laser is turned off.

Tips and tricks

.
■ Avoid damaging the cutting edge of sensitive
materials, e.g. coated chip boards or doors,
by sticking masking tape along the cutting line.
Another benefit of this is that it is easier to mark
a line on the tape than on a shiny surface. An
even more effective method of protecting the
cutting edges is to clamp a thin piece of wood
along the cutting line (this wood is also sawn).
on the material.
or
.
.
.
23
GB