Operation
Setting the cutting angle
♦
Undo the clamping screws
key
and pull the footplate
♦
Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the footplate
Push the footplate
locking pin engages in the toothing
♦
Retighten the clamping screws
key
.
NOTE
►
When using a cutting angle of 15°/30°/45°,
the pivoting blade guard
must be detached beforehand!
Setting the stroke rate
♦
Use the stroke rate adjusting wheel
required stroke rate .
Adjusting the pendulum stroke
♦
You can use the pendulum stroke switch
adjust the pendular movement of the saw blade
. You can achieve fine, clean-cut edges with-
out pendular movement (setting "0") . Deactivate
pendular movement when working on thin
workpieces . You can achieve an increasingly
fast work rate if the pendulum stroke is activated
(settings 1–3) .
Switching ON/OFF
Switching the appliance on:
Press the ON/OFF switch
Switching the appliance off:
Release the ON/OFF switch
Switching to continuous operation:
Press the ON/OFF switch
position with the ON/OFF switch lock button
Switching off continuous operation:
Press the ON/OFF switch
PSTD 800 B2
with the hex
to the rear .
to the front so that the
.
with the Hex
and splinter guard
to set the
to
.
.
and lock it in this
and release it again .
Switching the laser/working light
ON/OFF
ON/OFF switch:
Press the ON/OFF switch
required function is active .
LASER and WORKING LIGHT → WORKING
.
LIGHT → LASER → SWITCH OFF
Sawdust blowing function
Switching the sawdust blowing function on:
♦
Slide the sawdust blower function switch
the position
Supporting the extraction function:
♦
Slide the sawdust blower function switch
the position "0" .
Maintenance and cleaning
WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
■
The appliance must always be kept clean, dry
and free from oil or grease .
■
Use a soft, dry cloth to clean the housing .
WARNING!
■
If the supply cord of this power tool is dam-
aged, it must be replaced by a specially
prepared cord available through the service
organization .
■
Replace the saw blade
are too blunt for adequate sawing .
■
Clean the appliance after completing your
sawing work .
■
Remove any dirt (e .g . sawdust) . If necessary,
clean the saw blade mount with a brush or
compressed air .
.
for the until the
.
as soon as its teeth
GB │ MT
│
in
in
41
■