Herunterladen Inhalt Inhalt Diese Seite drucken

Additional Safety Information For Routers Operation; Switching On / Off; Setting The Speed; Changing Tools - Parkside PSFS 250 A1 Originalbetriebsanleitung

Kombi-fräser
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Only use cutting bits with the correct size shaft
diameter suitable for the speed of the electric tool.
Fix and secure the work piece to a
stable surface using clamps or other
means. If you only hold the work piece with
your hand or against your body, it will remain
unstable which could lead to a loss of control.
Operation
Never use the device for any purpose other than
the intended purpose and only use it with the origi-
nal parts and accessories. The use of parts or ac-
cessories other than those recommended in the
operating instructions could lead to you suffering
an injury. Use only an extension cable that has
been completely unrolled and is undamaged with
a capacity of at least 5 A.
WARNING: Do not use this tool for the creation
of notches in the vicinity of installations or openings
with live electric cables or in walls behind which
live electric cables could potentially be laid. The bit
could conduct electricity into the tool and this could
involve the risk of electric shock to the operator.
Trigger the circuit breaker or remove the fuse in
order to disconnect the relevant electric circuit.
Attention: Always hold the tool on the plastic
housing and always wear safety goggles when
working with the tool.
Switching ON / OFF (see Fig. A)
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch
Setting the speed (see Fig. B)
Turn the speed controller
direction to increase the speed.
Turn the speed controller
direction to reduce the speed.
Additional safety information for routers / Operation
.
4
.
4
in a clockwise
2
in an anticlockwise
2
Changing tools (see Fig. C)
Note: Only use combination cutter accessory
parts with a shaft diameter of ø 4.8 mm.
Hold the spindle lock button
Loosen the clamping nut
by turning in an anticlockwise direction.
Change the tool.
Block the spindle lock, tighten the clamping
nut
using the open-ended spanner
10
Bits:
The bits included are intended for the following
applications (see Fig. D).
Multi­purpose cutter (HSS)
Application: wood, particle board, plastic, alumini-
um and iron sheets
Slot cutter (HSS)
17
Application: wood, particle board, plastic
Sanding belts
:
16
Application: sanding wood
Note: Please use suitable accessories available
from your speciality retailer to cut wall tiles and /
or edit sheets of metal / light metal.

Installing sanding belts

Install the sanding belts

Setting the working depth

(see Fig. E)
Loosen the wing bolt
Slide the base plate
depth (to cut through completely set approx.
3.2 mm deeper than the material thickness).
The recommended maximum cutting depth for
wood is 13 mm *(only applies to multipurpose
cutter (HSS)
).
18
Retighten the wing bolt
pressed down.
11
with the wrench
10
.
14
:
18
:
as shown in Figure C.
16
.
5
to the desired working
7
.
5
GB/MT
14
19

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 102813

Inhaltsverzeichnis