Herunterladen Inhalt Inhalt Diese Seite drucken

Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Use; Switching On And Off - Parkside PASSK 20-Li A1 Originalbetriebsanleitung

Akku-kfzdrehschlagschrauber
Vorschau ausblenden Andere Handbücher für PASSK 20-Li A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 6
Connect the battery pack
battery charger
Insert the power plug into the socket . The control
LED
lights up red .
The green LED
indicates that the charging
process is complete and the battery pack
is ready for use .
CAUTION!
If the red control LED
that the battery pack
cannot be charged .
If the red and green control LEDs
flash, this means that the battery pack
defective .
Push the battery pack
Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
Push the rotation direction switch
middle position (lock) . Push the battery pack
into the handle until it clicks into place .
Removing the battery pack:
Press the release button
battery pack
.

Checking the battery charge level

Press the battery charge level button
the status of the battery (see also main diagram) .
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PASSK 20-Li A1
to the high-speed
(see Fig . A) .
flashes, this means
has overheated and
both
back into the appliance .
into the
and remove the
to check
as follows:

Use

Switching on and off

Switching on:
To start the appliance, press the ON/OFF
switch
and keep it pressed in .
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions .
Switching off:
Release the ON/OFF switch
appliance .
Setting/preselecting the rotation
is
speed/tightening torque
Press the torque preselection button
the required torque in stages .
Press the ON/OFF switch
speed/tightening torque . Increasing the pres-
sure increases the speed/tightening torque .
The tightening torque depends on the selected
speed/torque preselection and impact duration .
NOTE
However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening .
CAUTION!
The tightening torque actually attained must
always be checked with a torque wrench!
NOTE
The integrated motor brake ensures rapid
stoppage .

Changing the direction of rotation

Change the direction of rotation by pressing
the rotation direction switch
or right .

Fitting the socket

Push one of the supplied sockets
tool holder
lights up when the
is depressed lightly or fully .
to switch off the
lightly for a low
towards the left
onto the
.
GB │ IE
to select
 19

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis