Integrating The Machine Into The Network; Preparing The Installation - VHF N4+ Originalbetriebsanleitung

N4+ – Installing the machine
5.7 Integrating the machine into the
netw ork
The following diagram visualizes how commands are
sent to the machine using our network technology:
F . 14 D : H
IG IAGRAM OW COMMANDS ARE SENT OVER THE NETWORK
SX Virtual Link is similar to a device driver that transfers
data between DENTALCNC and the machine.
The network integration workflow is as follows:
1. Prepare the installation.
2. Configure the machine's network settings.
3. Configure SX Virtual Link and DENTALCNC.
4. Configure the webcam.

Preparing the installation

For integrating the machine into your network, you
will require the assistance of your IT specialist.
Ensure that your network is working without disrup-
tions. Network failures will lead to aborted jobs and
unusable machining results.
Do not contact customer support for setting up your
network or troubleshooting network issues.
Customer service will only help you with machine-
related issues.
If you want to control multiple machines with 1 CAM
computer, use our multi-machine control feature.
See the documentation for the manufacturing soft-
ware.
1. Plug the Ethernet cable into the network port at the
connection panel of the machine.
2. Plug the other end of the Ethernet cable into the
network port of the CAM computer. Do not use a
Original Operating Instructions: N4+
Version: 12/16/2021
router, hub or switch to connect the 2 units at this
point.
3. Ensure that you have administrator rights on the
CAM computer.
4. Install DENTALCAM & DENTALCNC.
During installation, the SX Virtual Link setup
program opens.
F . 15 T
IG HE FIRST VIEW OF THE
5. If the SX Virtual Link setup program did open,
continue with the next step.
If the SX Virtual Link setup program did not open,
open the installation program in the DENTALCAM
& DENTALCNC installation folder.
USB\Silex\Cosetup.exe
6. Follow the SX Virtual Link setup program until the
installation is finished.
7. Continue with the DENTALCAM & DENTALCNC
installation.
EN 21
SX V L
IRTUAL INK SETUP PROGRAM