Machine Overview; Front Side Of The Machine; Connection Panel; Working Chamber Door - VHF N4+ Originalbetriebsanleitung

EN 10
4

MACHINE OVERVIEW

With your N4+ you can process blanks of different
materials to create high quality objects for the dental
sector. You can find a list of the materials which you
can process with the machine in the manufacturing
software.
The machine is designed for wet machining.
During wet machining, the tools and blanks are
constantly being cooled by cooling liquid.

4.1 Front side of the machine

F . 1 F
IG RONT SIDE OF THE MACHINE
1. Connection panel & main power switch on the rear side
2. Identification plate
3. Recessed grip for opening the working chamber door

4. Working chamber door

5. View window to the working chamber
6. Cooling liquid drawer

4.2 Connection panel

F
4.3 Working chamber door
The working chamber door locks the working chamber
and protects the user from injuries during operation.
You can open and close the working chamber door
manually.
You cannot open the door when the machine is
switched off or while the axes are moving.
F
Original Operating Instructions: N4+
Version: 12/16/2021
N4+ – Machine overview
. 2 C
IG ONNECTION PANEL
1. Pneumatic connection (6 mm push-in fitting)
2. Network port (Ethernet RJ-45)
3. Power connection including glass fuse T6,3A L250V
4. Main power switch
To open or close the working chamber door, pull it
downwards or push it upwards with your hand. Use
the recessed grip of the door.
. 3 W
IG ORKING CHAMBER DOOR