N4+ – Troubleshooting
1. Verify that your compressor can permanently gen-
erate the required air pressure and volume flow.
Not every compressor is designed for
commercial use with dental machines.
2. If necessary, replace your compressor with one that
meets the recommendations.
Installing the pneumatics – on page 18
I have exchanged the tool magazine inserts
and now there are no holes for the tools
anymore
Tool magazine inserts are delivered without drilled
holes for tools. You drill them with the machine.
Use DENTALCNC to drill new holes into the new
inserts.
Original Operating Instructions: N4+
Version: 12/16/2021
EN 61