VHF N4+ Originalbetriebsanleitung Seite 23

N4+ – Installing the machine
Green check marks (marked orange) indicate that
the connections have been established.
F . 20 G
IG REEN CHECK MARKS INDICATE SUCCESSFUL CONNECTIONS
( )
MARKED ORANGE
15. In the SX Virtual Link application win-
dow, select the depicted icon.
The Options window opens.
16. In the Options window, activate the following
options:
Launch SX Virtual Link at Windows startup
n
Don't show SX Virtual Link main window on pro-
n
gram launch
Hide the main window if the close button is
n
clicked
17. Deactivate the Automatically connect newly discovered
USB devices option.
18. To save your settings, select [OK].
19. Start DENTALCNC.
20. Open the DENTALCNC Application settings with the
following icon in the main icon bar:
21. Open the General settings with the following icon in
the local icon bar:
22. Select the following icon next to the Port number
input field:
F . 21 D
IG ETERMINING THE PORT NUMBER
If DENTALCNC is able to determine the port
number, the number displays in the Port number
input field. The machine references.
23. In the SX Virtual Link application window, locate
the Ethernet address of the machine. It displays
behind the device name.
24. Enter the Ethernet address into the Machine Ethernet
25. Press <E
26. Activate the Launch application at Windows startup
27. Close DENTALCNC.
28. In the SX Virtual Link application window, right-
29. From the context menu, select Disconnect.
30. Right click on the entry starting with FTDI.
31. From the context menu, select Disconnect.
32. Start DENTALCNC.
33. (Optional) Install hub, router or switch to connect
Original Operating Instructions: N4+
Version: 12/16/2021
F . 22 T E
IG HE THERNET ADDRESS OF THE MACHINE
)
ORANGE
address input field in DENTALCNC.
Example: 84:25:3F:23:4A:F4
>.
NTER
From now on, DENTALCNC will connect and dis-
connect the machine.
option in DENTALCNC.
From now on, DENTALCNC will launch with Win-
dows . This is required to automate the connection
®
process.
If you do not close DENTALCNC now, your changes
may not be saved.
click on SMI USB 2.0 Camera.
In the SX Virtual Link application window, the 2
check marks no longer display.
DENTALCNC establishes the connection to the
machine. The 2 check marks display again.
the computer and the machine. This may require
additional configuration.
EN 23
(
MARKED