Hot Water Dispensing; Standby; Power-Saving Mode - Faema Faemina Gebrauch Und Installation

Hot water dispensing

Scalding hazard!
Warning: perform the operations with the greatest care Use the appropriate insulating devices to
move the water and steam nozzles.
1
Position a container in line with the hot water tube and
press the dispensing button.

Standby

The hot-water button has a second function, enabling the machine to be switched to standby.
1
To access the function, hold the button down for 3 seconds
until the countdown finishes and the display switches off.
During the standby phase, the button LED flashes.
Placing the machine into standby mode can also be configured after a set period of time without use. This can be selected
from the customer programming menu (CUSTOMER PROGRAMMING/CUSTOMER PARAMETERS/SERVICE TIME/
STANDBY).

Power-saving mode

94.0°C
* * * * * * * * * *
STANDBY
2
* * * * * * * * * *
60''
2
When the desired dose is obtained, press the button
again to stop hot water dispensing.
2
To resume operation of the machine, press the hot-water
button again for a few seconds until the display restarts.
When the machine is unused for 60 seconds,
the display goes blank.
To resume normal operation, press any key:
the display will restart and dispensing begins
immediately.
94.0°C
94.0°
15