Dispensing Of Beverages - Chocolate / Solubles (Where Contemplated); Dispensing Of Beverages - Hot Water - Faema BARCODE Gebrauch Und Installation

8.2 Dispensing of beverages - Chocolate / Solubles (where contemplated)

Preliminary operations
Place the cup (or cups) under dispenser (1) of the required
group.
Soluble beverage dispenser
Press the chocolate (or other soluble beverage) dispensing
button corresponding to the required dose. The led in the
selected button will come on and dispensing will begin.
Dispensing will stop automatically.
Beverage dispensing can be stopped before the set time by
pressing the same key again.
Mixed Soluble dispenser
Combined dispensing that can include coffee, milk and solubles
beverages.
Selection customization, with the sequence and duration
of the dispensing cycles for each beverage, is done by the
installer.
Insert the tube (40) into the milk container.
Press the mixed soluble dispensing button corresponding to
the required dose. The led in the selected button will come on
and dispensing will begin. Dispensing will stop automatically.
Beverage dispensing can be stopped before the set time by
pressing the same key again.

8.3 Dispensing of beverages - hot water

Scalding hazard! Use the appropriate insulating
devices to move the water and steam wands.
HOT WATER: GENERAL INSTRUCTIONS
Place the appropriate container under the hot water dispenser
(14). Dispensing can be dosed automatically or occur in
continuous mode (manually).
Note: hot water dispensing cannot take place during
coffee dispensing.
Dispensing with automatic dosing
Press one of the hot water dispending keys (12dt) correspond-
ing to the desired dose.
The programmed dose of hot water will pour from the dispenser
(14) and will stop automatically.
Note Dispensing may be stopped by pressing the (12dt) key.
Pressing the (12dt) key does not change the parameters set
during the programming phase.
Manual dispensing
Press the hot water dispensing key (12c).
Hot water is dispensed continuously until the water key is
pressed again (12c) to stop it.
In some product configurations, hot water dispensing can occur
through the dispensing nozzle (1). The special key (32) on the
selection pad must be enabled by the installer.
Downloaded from www.Manualslib.com manuals search engine
40
12c
12dt
14
Hot water dispensing nozzle
58
1
32
1
.