Installation Rules - Faema Faemina Gebrauch Und Installation

2.2 Installation Rules

• Before plugging in the appliance, make sure that the information on the nameplate (voltage, etc.)
matches that of the electrical system.
• Check the condition of the power-supply cord; if it is damaged it must be replaced.
• Completely unwind the power-supply cable.
• Do not wind the cable above the work surface or the surface of the table where it can be pulled
by children or involuntarily be the cause of entanglement.
A short power-supply cable is supplied to reduce the risks deriving from entanglement in
the case of a longer cable. However longer power-supply cables or detachable extension
cords are available and these can be used if attention is paid in using them:
• The electrical power marked on the extension cord must be at least equal to the electrical
power of the appliance;
• The extension cord must be a 3-wire cable with an earth wire;
• The longer cable must be arranged in such a way as not to fall onto the work surface or
the surface of the table where it can be pulled by children or involuntarily be the cause
of entanglement.
NOTE:
• If the machine is destined for use in professional applications:
the appliance must be placed in areas where the use and maintenance are reserved for
specifically trained personnel.
• If the machine is destined for use in supervised applications:
the appliance must be placed in places where it can in any case be supervised by
specifically trained personnel.
• The coffee machine should sit on a flat, stable surface at least 20 mm from walls and from the
counter. Keep in mind that the highest surface on the machine (the cup tray) sits at a height of at
least 1.5 meters. Make sure there is a shelf nearby for accessories.
• Room temperature must range between 10° and 32 °C (50°F and 90 °F).
• Do not install in rooms, such as for example professional kitchens, that are cleaned with jets of
water.
• Do not obstruct openings or ventilation and heat vents.
• Do not install the appliance outdoors.
• Do not install or use the machine in potentially explosive environments.
• Do not install the machine in the presence of flammable substances.
4