Hot Water Dispensing - Faema Enova S Gebrauch Und Installation

15. Hot water dispensing

Scalding hazard!
insulating devices to move the water and steam
wands.
Dosed function
After having positioned the appropriate container under
the hot water nozzle (8), raise the hot water dispensing
lever (9): afterwards, the lever automatically returns to the
original position. The hot water will be dispensed and will
stop automatically.
The water can be interrupted at any time by raising the hot
water lever again (9).
Continous Function
Raise the hot water dispensing lever (9) and maintain it
raised for approximately 3 seconds.
Hot water will be issued continuously until a following raise
of the hot water dispensing lever (9) which will stop this
function.
In continuous function the progrmmed dosed in the lever
is not changed.
1 DISPENSER UNIT MACHINES
After having positioned the appropriate container under
the hot water nozzle (8), distribution is made in two ways.
Dosed Function
Press the hot water distribution key (9) hot water will be
issued and will stop automatically upon completion.
The distribution may be interrupted at any time by pressing
the previously active key again (shown by the lighted led).
Continous Function
Press the hot water distribution key (9) and keep pressed
for approximately 3 seconds.
Hot water will be issued continuously until the hot water
key (9) is pressed again to stop this function.
In continuous function the progrmmed dosed in the key
is not changed.
Use the appropriate
11 EN
9
9
8
1 Dispenser unit machines
8