Handling And Transportation; Assistance And Repairs; Warranty Coverage - Stiga AM 98 Li 48 V1 Gebrauchsanweisung

9.3.4 Repairing or changing tyres
The tyres are "Tubeless" and must be replaced
or repaired if punctured by a specialized tyre
repairer following the procedures required for this
kind of tyre.
10. STORING
When you intend to put your machine away for
more than 30 days:
1. Remove the ignition key.
2. Clean the machine thoroughly.
3. Check the machine for any damage. If
necessary, contact the authorised service
centre.
4. Store the machine:
• with the cutting-means assembly lowered
• the transmission engaged;
• in a dry place;
• sheltered from weather conditions, in the
shade, at a recommended temperature
ranging between +0 and +40°C;
• and covered with a sheet where possible;
• in a place where children cannot get to it;
• making sure that keys or tools used for
maintenance are removed.
WARNING
The battery must be fully charged at least once a
month and always before resuming work.
When restarting the machine, set it up as
indicated in chapter "7. Use of the machine" .

11. HANDLING AND TRANSPORTATION

• When handling the machine, always:
1. disengage the cutting means;
2. bring the cutting-means assembly to the
highest position;
3. Turn off the machine and remove the
ignition key.
4. disengage the transmission (par. 6.4).
• When transporting the machine on a vehicle or
trailer, always:
• use access ramps of a width, length and
sturdiness appropriate for the weight and
size of the machine;
• raise the plate to the maximum cutting height
using the adjustment lever;
• load the machine with the electric motor
switched off, with the key removed from the
ignition, without a driver and pushed by an
adequate number of people;
• lower the cutting-means assembly
completely.
• switch off the machine and remove the key
from the ignition;
• engage the transmission (par. 6.4);
• secure the machine to the vehicle, using the
two rear hooks. Do not secure the machine
to elements that could get damaged.
SAFETY INSTRUCTIONS
In case of any doubt regarding being unable to
carry out the handling or transport of the machine
safely, please contact the Service Centre.

12. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can be
performed by the user. Any regulations and
maintenance operations not described herein
must be carried out by your Dealer or Authorised
Service Centre, which have the necessary
knowledge and equipment to ensure that
the work is carried out correctly, maintaining
the correct degree of safety and the original
operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the Warranty and all obligations and
responsibilities of the Manufacturer.
• Only authorised service centres can carry out
guaranteed repairs and maintenance.
• The authorised service centres only use
genuine spare parts. Genuine spare parts and
attachments have been designed specifically
for the machines.
• Non-original parts and attachments are not
approved; use of non-original spare parts and
attachments will jeopardize the safety of the
machine and relieve the Manufacturer from all
obligations or liabilities.
• It is advisable to send your machine once
a year to an authorized service workshop
for servicing, assistance and safety device
inspection.

13. WARRANTY COVERAGE

The warranty conditions are intended for
consumers only, i.e. non-professional operators.
The warranty covers all material quality and
manufacturing defects recognised during the
warranty period by your Dealer or Authorised
Service Centre. The warranty is restricted to the
repair or replacement of components recognised
as faulty.
EN - 22