Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The icon (fig. 9.F) and
(fig. 9.L) remain lit and the
battery LEDs 2 and 4 contin-
ue to flash.
6. The icon (fig. 9.F) remains
lit and the battery LEDs 1, 4
and 5 continue to flash.
7. The icons (fig. 9.F) and
(fig. 9.L) remain lit and
the battery LEDs 1 and 3
continue to flash.
8. The icon (fig. 9.F) remains
lit and the battery LEDs 1,3
and 5 continue to flash.
9. The icons (fig. 9.F) and
(fig. 9.L) remain lit and the
battery LEDs 1, 2 and 4
continue to flash.
10. The icons (fig. 9.F) and
(fig. 9.l) remain lit and
the battery LEDs 1, 2, 4
and 5 continue to flash.
overheating/sub-heating
of the battery due to:
1. Heavy working
conditions.
2. Unsuitable
environmental
conditions.
Current overload on the
cutting means due to:
1. Heavy working
conditions.
2. Obstructions
hindering the rotation
of the cutting means.
3. Cutting-means
assembly is full of
grass.
Cutting means motors
overheating due to:
Heavy working
conditions.
Cutting means motors
stalling due to:
1. Heavy working
conditions.
2. Obstructions
hindering the rotation
of the cutting means.
3. Cutting-means
assembly is full of
grass.
Overheating of the drive
motor due to:
1. Drive motor under
strain.
2. Slope too steep.
3. Excessive presence
of mud on the wheels.
The machine is started
with the direction lever
(fig. 8.D.1) not released
(not in neutral position).
EN - 25
Turn the machine off, wait at least 5 minutes and then
re-start it.
Reduce the travel speed
Increase the cutting height:
Work in an environment suitable to the machine
operational conditions.
Reduce the travel speed
Increase the cutting height:
Remove the obstructions.
Clean the cutting-means assembly.
Turn the machine off, wait at least 5 minutes and then
re-start it.
Reduce the travel speed
Increase the cutting height:
Reduce the travel speed
Increase the cutting height:
Remove the obstructions.
Clean the cutting-means assembly.
Turn off the machine and wait at least 5 minutes
before repeating the start-up procedure.
Reduce the travel speed
Reduce the speed and check the gradient of the
slope you are working on.
Make sure the wheels are not blocked and clean
them if necessary.
Turn the machine off and repeat the starting
procedure only after making sure that the direction
lever (fig. 8.D.1) is in neutral (par. 6.4.1).
Werbung
Inhaltsverzeichnis
