Push-Button Panel - Stiga AM 98 Li 48 V1 Gebrauchsanweisung

6.5 CUTTING HEIGHT ADJUSTMENT
HANDLE
Use this handle to raise and lower the cutting-
means assembly to one of the 8 different cutting
heights (fig. 8.E).
The eight positions are shown
as «1» to «8» on the plate, and
correspond to the same number of
cutting heights between 3 and 8 cm.
To switch from one position to
another, press the release lever
(fig. 8.E.1) and move the handle
(fig. 8.E.2) back into one of the stop
notches.
6.6 AUXILIARY PORT FOR USB
ACCESSORIES
This port (fig. 8.F) can be used to recharge USB
devices. It is only used for recharging.
The port has no communication function with the
connected USB device.
The socket is only live when the key (fig. 8.A) is
inserted all the way.
NOTICE
Do not charge the accessory connected to the
USB port in rainy, humid or high temperature
conditions with direct exposure to sunlight. If
used in these conditions the warranty will be
invalidated and the manufacturer will not be held
liable for any problems.
Do not open the cap of the USB port in rainy or
dusty areas.
The manufacturer declines all liability for damage
caused to the accessory connected to the USB
port or for any loss of data during its use.
6.7 BATTERY CHARGING SOCKET
The charging socket
flap (fig. 8.G) at the rear of the machine.
To charge the battery follow the instructions
provided in par. 8.2.2.

6.8 PUSH-BUTTON PANEL

The machine is equipped with a push-button
panel (fig.8.H) whose layout differs depending on
the model (fig.9) and includes the controls and
indicator lights described below.
is accessible by lifting the
Machine start push-button
With the key inserted all the way,
this push-button (fig. 9.A) turns
the machine on and enables all
functions. A beep is heard when the
machine is turned on.
NOTE
If all safety conditions are met, the
"READY" icon (fig. 9.M) is lit and the
machine is ready to be used
(see chapter 7.4).
Battery LED
The LEDs (fig. 9.B) normally
indicate the battery charge level
of the machine, but specific
combinations of their illuminated
status provide some information
regarding machine malfunctions
(see chap. 15).
Headlight switch on button
By pressing the push-button
fig. 9.C the headlights are switched
on/off.
"Bluetooth" icon
The icon fig. 9.D is lit when the
machine and the data exchange
device are connected.
Cutting means engage/
disengage push-button
By pressing the push-button
fig. 9.D the cutting means are
engaged/disengaged.
• The cutting means become
• When disengaged, a brake is
NOTE
If the cutting means are engaged
without respecting the safety
conditions, the machine will shut
down or cannot be turned on
(see par. 7.2.2).
Caution Icon
The iconfig. 9.F, if lit, indicates failure
to comply with safety conditions or a
possible malfunction of the machine
(see chap. 15).
Emergency push-button icon
The (icon fig. 9.G) is lit when the
emergency push-button is enabled
(see par. 6.2).
EN - 11
operational after a few seconds
from being engaged.
enabled which stops the cutting
devices from rotating within a few
seconds.