Use Limitations; Maintenance, Storage; Environmental Protection - Stiga AM 98 Li 48 V1 Gebrauchsanweisung

• Pay attention when using attachments that can
alter the stability of the machine, especially on
slopes.
• Always keep hands and feet away from the
cutting means, when starting and when using
the machine.
• Keep hands and feet away from the seat
support. There is a risk of crushing injuries.
CAUTION
The cutting means will continue to rotate for a few
seconds after disengagement or after you have
switched off the motor.
CAUTION
Pay attention to cutting-means assemblies with
more than one cutting means, as a rotating
cutting means can trigger the rotation of the
others.
SAFETY INSTRUCTIONS
If something breaks or an accident occurs during
mowing, turn off the motor immediately and move
the machine away to prevent further damage; if
an accident occurs with injuries or third parties
are injured, carry out the first aid measures most
suitable for the situation immediately and contact
the medical authorities for any necessary health
care. Carefully remove any debris which could
cause damage or injury to persons or animals if
ignored.

Use limitations

• Never operate the machine with guards
damaged, missing or incorrectly assembled
(grass catcher, side discharge guards rear
discharge guards)
• Don't use the machine if the attachments/tools
are not installed in their seats.
• Never disengage, deactivate, remove or
tamper with the safety systems/micro switches
installed.
• Do not strain the machine too much and do not
use a machine unsuitable for heavy work; the
use of a suitable machine reduces risks and
improves the quality of work.
• The machine has not been approved for use
on public roads. It must be used (as indicated
by the highway code) in private areas closed
to traffic.

3.4 MAINTENANCE, STORAGE

Ensure regular maintenance and correct storage
to maintain machine safety and high performance
levels.
Maintenance
• Never use the machine with worn or damaged
parts. Faulty or worn-out parts must always be
replaced and never repaired.
• Be careful during adjustment of the machine
to prevent entrapment of the fingers between
moving parts of the cutting means and fixed
parts of the machine.
• Have your machine serviced by a qualified
repair person using only original replacement
parts. This will ensure that the safety of the
machine is maintained.
• Do not repair the battery. Repair work must
be done by the manufacturer or a specialised
service centre.
SAFETY INSTRUCTIONS
The noise and vibration levels shown in these
instructions are the maximum levels for use of
the machine. The use of an unbalanced cutting
element, the excessive speed of movement, or
the absence of maintenance have a significant
influence on noise emissions and vibrations.
Consequently, it is necessary to take preventive
steps to eliminate possible damage due to high
levels of noise and stress from vibration. Maintain
the machine well, wear ear protection devices,
and take breaks while working.
Storage
To reduce fire risks, do not leave containers with
debris inside a room.

3.5 ENVIRONMENTAL PROTECTION

Safeguarding the environment must be a relevant
and priority aspect of machine use, of benefit to
the community and the environment we live in.
• Comply with local regulations for the disposal
of packaging, deteriorated parts or any
elements with a strong environmental impact;
this waste must not be disposed of as normal
waste, it must be separated and taken to
specified waste disposal centres where the
material will be recycled.
• Scrupulously comply with local regulations for
the disposal of waste materials
• When the machine is withdrawn from service,
do not dispose of it in the environment, but take
it to a waste disposal facility in accordance with
the local regulations in force.
Do not throw electrical equipment away
with domestic waste. According to the
European Directive 2012/19/EU on
electrical and electronic equipment
waste and its implementation in
compliance with national standards, old electrical
EN - 6