Stiga AM 98 Li 48 V1 Gebrauchsanweisung Seite 135

Operator on board icon
The (icon fig. 9.H) is lit when the
operator is not sat on the seat
(see par. 7.2.2).
Transmission engagement /
disengagement lever icon
The icon (fig. 9.l) is lit up when the
transmission is not engaged
(see par. 6.3 and chap. 15).
Controller and/or motor over-
heating icon
The (icon fig. 9.L) indicates
overheating of the electrical
components. See chap.15.
"Ready" icon
The icon (fig. 9.M) is lit with the key
fully inserted and after pressing the
start button.
6.8.1 Push-button (type "I") fig. 9
Gear mode push-button
When started, the machine
automatically runs in "NORMAL"
mode. The push-button (fig. 9.N)
switches between "FAST" and
"NORMAL" gear.
Gear mode icon
The icon (fig. 9.O) is lit when the
machine is in "FAST" gear mode.
6.8.2 Push-button (type "II") fig. 9
"Normal/slow" gear mode
push-button
When started, the machine
automatically runs in "NORMAL"
mode. The push-button (fig. 9.P)
switches between "SLOW" and
"NORMAL" gear. .
"Normal/slow" gear mode
icon
The icon (fig. 9.Q) is lit when
the machine is in "SLOW" gear
mode.
"Normal/fast" gear mode
push-button
When started, the machine
automatically runs in "NORMAL"
mode. The push-button (fig. 9.R)
switches between "FAST" and
"NORMAL" gear.
"Normal/fast" gear mode icon
The icon (fig. 9.S) is lit when the
machine is in "FAST" gear mode.
Cutting speed push-button
When started, the machine
automatically runs in "NORMAL"
mode. The button (fig. 9.T)
enables the three cutting
device speeds in the following
sequence: "NORMAL" >
"BOOST" > "NORMAL" > "ECO" >
"NORMAL".
"ECO" cutting speed icon
The icon (fig. 9.U) is lit when
the machine is in "ECO" cutting
mode and remains off when it
switches back to "NORMAL"
mode. The "eco" mode allows
for significant saving of battery
power.
NOTE
We do not recommend the use of
the "ECO" function during heavy
grass cutting conditions (cutting
of thick, high, wet grass).
EN - 12