Assembly Of The Ceiling Tube - Derungs Dmed Triango 100 C Duo Montage- Und Gebrauchsanweisungen


Draw 6 drill marks.

Observe the position of opening «E» for the power
connection.
CAREFUL
Use protective equipment
manufacturer's instructions.

Drill holes and blow out with a bellows.

Check the hole distances.

Hold the ceiling bracket to the ceiling and hammer in the
six fastening anchors.
Tighten the fastener according to manufacturer's

instructions.
E
in line with the tool
E
DANGER
Danger to life through an electric shock.

Do not turn on the power supply before the luminaire
head has been installed.

This device must only be connected to a power grid
with a protective ground conductor (PE) to prevent risk
of electric shock

Connect the power.

3.5. Assembly of the ceiling tube

C

Pull the 4-pin plug of the Y-cable through the opening
«F» in the ceiling brackets before inserting the ceiling
tube
Insert the ceiling tube "A" into the ceiling holder.

Secure the safety screw "C"and the M8 nut.

C

Tighten the M8 safety screw «C» and the nut (20 Nm).

Tighten all 4 grub screws «F» (5 Nm).
2x

Connect the plug of the Y-cable with the power supply
plug.
ENG
F
A
F
21