Assembly Iris Led 10 C; Load Data; Assembly Arm System - Derungs D med IRIS LED 10 Montage- Und Gebrauchsanweisung

ENG
3

ASSEMBLY IRIS LED 10 C

3.1

Load data

Bending moment M
B
Vertical weight F
G
3.2

Assembly arm system

DANGER
Assembly by qualified personnel

Assembly must be carried out by qualified
personnel only. Lack of appropriate knowledge
could be life-threatening.
DANGER
Life-threatening danger from falling luminaire

The ceiling must be made of solid concrete to
guarantee a secure hold.
DANGER
Electric shocks are life threatening

It must be possible to separate the light from
the mains by an external all-pole switch
(not included).
DANGER
Electric shocks are life-threatening

Voltage supply from the power connection
must be protected on all poles by means of an
overcurrent release (according to national
installation requirements; it is not included in
the scope of supply).

Pay attention to the minimum distance of the
ceiling tube!

Saw ceiling tube to the desired length at the top
end using a metal saw and deburr.

Remove fastening screw.
CAUTION
Prior to assembly, check the reach and position of
the luminaire in the direction of the desired field.
26
90Nm
118N




The
incorrectly

Insert ceiling tube 1 into ceiling bracket 2 and
drill with Ø= 9mm 3. Use the existing hole in
the ceiling bearing as a guide.
Make 4 opposited drill
(Ø13mm), note the position of the Ø60mm drill
hole for electrical connections
Check clearances
Drill the bore holes, then blow them out using
bellows
WARNING
light will fall if
The threaded pin must be screwed in fully and
correctly.
hole markings
fastening is done