Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
SAFETY INSTRUCTIONS
2.1
Intendend use
The luminaire Dmed® Halux N50 is an examination
luminaire. It is designed to illuminate a patient's body locally
to support diagnosis. The diagnosis can be interrupted at any
time due to a light failure without endangering the patient. The
lamp is not intended for use in operating rooms.
2.2
User profiles
Medical Specialist
Are all persons who have completed medical training and
work in their trained professional field.
Cleaning specialist
Is familiar with national and workplace hygiene regulations.
Electrician
He is trained in electronics and electrical engineering and
knows the relevant standards and regulations.
Qualified specialist
Due to his technical training, knowledge and experience as
well as knowledge of the regulations, he is able to carry out
the assembly / disassembly.
2.3
Safety instructions
Operation by medical specialist
The manual is part of the product and must be kept and
made available to all subsequent users.
All work on the lamp (including repairs) may only be
carried out by a qualified electrician. Installation may only
be carried out by a qualified electrician.
The lamp must not be changed or manipulated. Only
approved original parts may be used. Other than the
intended use with the original parts can lead to other
technical values and life-threatening dangers.
Operation in hazardous areas is prohibited. The power
supply of the lamp is a potential ignition source.
The luminaire may only be operated in dry and dust-free
rooms.
The lamp must not burn without supervision..
For luminaires of protection class I, the protective
conductor must be connected to the luminaire housing.
Do not use a damaged lamp. Defective cables are also
a potential hazard. Do not place cables near heat
sources or on sharp edges.
Never load the lamp head or the arm system additionally.
The luminaire must not be covered with a cloth or similar
in the operating state.
The ventilation openings (if present) must always be free
in case of operation!
Do not operate the luminaire near external heat sources
that exceed the maximum ambient temperature of the
luminaire.
The luminaire must not be used outside the intended
ambient conditions.
Do not use together with medical devices that can react
sensitively to a light spectrum in the visible range (e.g.
pulsating light and/or light with high illuminance).
Luminaire may only be used for the purpose mentioned
here..
The manufacturer cannot be held responsible for
damage caused as a result of use other than in
accordance with the intended use, or non-compliance
with safety instructions and warnings.
The luminaire is designed for a service life of 10 years.
When using several lights simultaneously, the total
illuminance Ee in the light field 1000W/m² must not be
exceeded during operation.
2.4
Warning levels
DANGER
Warnings of hazards which, if not avoided, could result in
death or serious injury.
WARNING
Warnings of dangers which, if not avoided, could result in
injury.
CAUTION
Warnings of dangers that can lead to material damage if
the actions are not observed.
3.
ASSEMBLY
3.1
Assembly instruction
Fastening material is not included in the scope of
delivery.
The luminaires are equipped with a pin connection. The
luminaire must therefore be connected in one of the
accessories mentioned in section 8.
If the "wall bracket" accessory is used, installation must
be carried out by a specialist.
The wall must ensure a firm hold.
Only use fixing material that is suitable for the
corresponding substrate.
3.2
Load data
Bending moment M
B
Vertical weight F
G
ENG
25Nm
90N
15
Werbung
Inhaltsverzeichnis
Fehlerbehebung
