Number Of Data Bits; Transmit Code; Position Value; Position - TR-Electronic C 58 Serie Benutzerhandbuch

Example 2
Measuring system:
-
-
-
MSB
1 2
0 0 0
Number of revolutions

7.2.2 Number of data bits

The parameter Number of data bits defines the number of reserved bits for the
measuring system position.
Thereby in the transmission format "Tree format no" the position of the 2
position bit to the MSB-bit is defined.
In case of the transmission format "Tree format yes" the Number of data
bits required for the programmed Total number of steps must be typed in
exactly.
lower limit
upper limit
default

7.2.3 Transmit code

Selection
Binary
Gray
BCD

7.3 Position value

7.3.1 Position

In the online state in the field Position the current measuring system position is
displayed.
With entering of a value into the field Position the measuring system can be
adjusted on the desired position value. The new position is set if the function Data
write to device is executed.
desired position value < programmed Total number of steps
Printed in the Federal Republic of Germany
07/30/2020
(related to 25 clocks)
1024 steps/revolution (10 bits)
512 revolutions (9 bits)
--> Total number of steps = 19 bits, this corresponds to 19 data bits
3 4 – 12
18 10
P 2 – P 2
Number of steps per revolution
Description
SSI output code = Binary
SSI output code = Gray
SSI output code = BCD
TR - ECE - BA - DGB - 0039 - 14
13 – 22 23 24 25
9 0
P 2 – P 2 0 0 0
8
32
24
LSB
Default
X
 TR-Electronic GmbH 2005, All Rights Reserved
Page 93 of 107
0
-