Resolution (Number Of Steps Per Revolution); Hysteresis; Preset Value; Preset Input - TR-Electronic C 58 Serie Benutzerhandbuch

TRWinProg Parameterization: CM_58

6.1.2.3 Resolution (Number of steps per revolution)

Indicates how many steps the measuring system outputs for one revolution of the
measuring system shaft.

6.1.3 Hysteresis

Caused by the magnetic scanning unit, unwanted edge jitter on the lowest-order bit
(LSB bit) can occur. To prevent this, a hysteresis of one step can be added.
Selection
Activated
Inactive

6.1.4 Preset value

The parameter defines the position value, on which the measuring system is adjusted
when the preset-adjustment-function is executed via the Preset-input.
Preset value
lower limit
upper limit
default

6.1.5 Preset input

If the Preset inputs are not used, they should be disabled to suppress interference.
Selection
enabled
disabled
 TR-Electronic GmbH 2005, All Rights Reserved
Page 86 of 107
Description
with hysteresis
without hysteresis
< programmed Total number of steps
Risk of injury and damage to property by an actual value jump when the
Preset adjustment function is performed!
• The preset adjustment function should only be performed when the
measuring system is at rest, otherwise the resulting actual value jump must
be permitted in the program and application!
Description
Preset adjustment function active
Preset adjustment function inactive
TR - ECE - BA - DGB - 0039 - 14
0
16 777 215
0
Default
X
Default
user-specific
Printed in the Federal Republic of Germany
07/30/2020