Maintenance; Guarantee; Stimulator Maintenance; Belt Maintenance - Compex COREBELT 5.0 Bedienungsanleitung

EN
Reset to factory settings
• If you experience any issue when pairing the device with your smartphone (i.e. not able to pair the device
with the smartphone), try to reset the device to the factory settings. This will clean the device of all paired
links. To do so:
1. Make sure the device is turned on and out of stimulation.
2. Press and hold first the - and then the + intensity button.
3. While keeping both buttons pressed, wait (3 seconds) until the device restarts.

8. MAINTENANCE

GUARANTEE

See the attached leaflet.

STIMULATOR MAINTENANCE

Your stimulator does not require calibration or periodic maintenance. However, when needed (at least once every
two months) clean with a soft cloth and solvent-free alcohol-based detergent. Use as little liquid as possible to
clean the device. Do not disassemble the stimulator or the belt as they contain high-voltage components which
could cause electrocution. If your stimulator or belt contains parts that appear to be worn or faulty, please
contact Compex customer service.
There are no user-serviceable parts inside the unit. If a malfunction occurs, discontinue use immediately and
contact Compex customer service.

BELT MAINTENANCE

Your belt can be hand washed only. It is recommended to wash it at least every two months. Before washing
it with a mild soap, make sure that the stimulator and the electrodes have been removed. Avoid immersing the
holster in the water and follow the label instruction of the belt when washing it.
20