Troubleshooting; Maintenance, Cleaning & Storage - Compex FIXX MINI Bedienungsanleitung

EN
INTRODUCTION
Compex® Fixx™ Mini provides the ultimate portable "on the go" deep tissue massage for sore and overworked
muscles. Fixx™ Mini adjusts to 3 different speeds ranging from 1500, 2000, and 2500 percussions per minute.
Combining speed and hand pressure customizes massage to meet your needs and requirements for recovery.
Fixx™ Mini can help reduce soreness, loosen tight muscles, and can be used for warm up prior to activity.
OPERATING INSTRUCTIONS
1. Connect the charging plug into wall outlet. Charge 1-1.5 hours before use.
2. When charging Fixx™ Mini a red light appears. Once the battery is fully charged, a green light appears.
3. Before use, make sure Fixx™ Mini is off. Then, place the ball on to the metal shaft with slight pressure until
the shaft stops inside the ball. Turn clockwise until ball is secured in place. The ball must be connected
prior to operating the Fixx™ Mini.
4. To turn on, hold power button down until lights come on. Press power button again to start first level speed
1 and press again to increase speed to second level speed 2 and then again to third level speed 3.
5. There is one indicator light on the Fixx™ Mini body showing green for power on. The indicator will show red
when battery running lower than 25% of its capacity.
6. To turn off, press and hold power button down.
7. To remove ball, turn Fixx™ Mini off and turn ball counterclockwise and pull ball away from the shaft.
Use antibacterial or alcohol wipes to clean ball between uses.

TROUBLESHOOTING

• If Fixx™ Mini will not power on, charge battery until fully charged.
• If ball will not remove from shaft, turn counterclockwise to remove.
• If battery will not charge, check connections of power cord connected to Fixx™ Mini or wall plug in power
outlet.
• If Fixx™ Mini disconnects from wand handle, check to assure both tabs are turned and locked into slots of
the wand handle end.
MAINTENANCE, CLEANING & STORAGE
• Wipe down with damp towel to clean device, then dry.
• Wipe ball and/or tips and grip with anti-bacterial wipes to prevent any bacteria contamination.
2