Fault Indication At The Control Device - Aventics Marex OS II Bedienungsanleitung

7.3

Fault indication at the control device

The control device in Marex OS II system is the MPC. For each propulsion system one MPC must be installed.
As essential indication and operating elements the MPC provides:
 display 2 x 20 characters
 button „Escape"
 button „Select"
For operation the cover has to be opened in case of the variants "MPC cabinet" and "MPC plus".
An error is signaled by means of a flashing "E" in the display of the faulty control system.
MPC modular MPC modular
MPC OEM MPC OEM
speed speed speed 15 % 15 % 15 %
gear gear gear NEUTRAL NEUTRAL NEUTRAL
The following user entries are possible:
button „Select"
ESC
button „Escape"
MPC cabinet MPC cabinet
open cover open cover
speed speed
gear gear
button "Escape" button "Escape"
ROTATE
Depending on the rotation direction of the button "Select" you can move up and down
the menu or increase or decrease a parameter value.
PRESS
By pressing the button "Select" on there are the following possibilities depending on
the selected line:
< > access the next lower menu level
<xxx> go into change mode, where xxx can be modified
store the modified value yyy
yyy
<ESC> access the next higher menu level
PRESS
By pressing the button "Escape" the next higher menu level is accessed or the
modification of a parameter is abandoned. The parameter remains unchanged then.
speed speed 15 % 15 %
gear gear NEUTRAL NEUTRAL
display display
0.0 mA 0.0 mA
NEUTRAL NEUTRAL
button "Select" button "Select"
MPC plus MPC plus
open cover open cover
speed speed 15 % 15 %
gear gear NEUTRAL NEUTRAL
The flashing "E" in the upper The flashing "E" in the upper
right corner of the display signals right corner of the display signals
that the MPC has noted an error. that the MPC has noted an error.