Balluff BNI IOF-329-P02-Z038 Betriebsanleitung Seite 215

BNI IOF-329-P02-Z038
Safe I/O Module, Safety over IO-Link
IP67 Module
15
Diagnostics
Error code
Error
class
Display PROFINET
0x1000
0x1001
0x1002
0x1003
27 external
3)
0x1004
0x1005
0x1006
0x1007
28
32
33
34
35
39
internal
41
42
43
44
45
47 external
The discrepancy time must be greater than the input delay.
3)
www.balluff.com
Cause Trigger
Discrepancy error on a
Input wiring
port with 1oo2 sensor
(sensors)
analysis/sensor valence
Non-permissible
interrupt
Control synchronization
failed
Software cycle time
monitoring failed
Input signal processing
failed
Internal device
Input signal read failed
error
Self-test error
Control synchronization
failed
Software procedure
error
Startup successfully
None
concluded
Initialization failed
Internal device
error
Startup failed
A new F-destination
Device
address was set on the
configuration
device
Effect Remedy
Check input circuitry and input
configuration (discrepancy
time and if necessary input
delay) as well as the
connected devices.
Acknowledge device on
controller side.
Restart device and replace if
needed.
Input signal delay, adjust if
necessary. Restart device and
replace if needed.
Check voltage supply. Input
signal delay, adjust if
necessary. Restart device and
replace if needed.
Restart device and replace if
needed.
None
Check voltage supply. Restart
device and replace if needed.
Check voltage supply and
IO-Link communication.
Restart device and replace if
needed.
Restart device
english 97