Balluff BNI IOF-329-P02-Z038 Betriebsanleitung Seite 122

BNI IOF-329-P02-Z038
Safe I/O Module, Safety over IO-Link
IP67 Module
10
11
12
13
14
4
8
Configuration of the PROFIsafe connection
8.1 Possibilities for setting module parameters
8.2 Safety I/O settings
8.3 PROFIsafe settings
9
Configuring the overall module
9.1 IO-Link projecting
9.2 Cycle time
9.3 Validation mode
9.4 Parameter Server
9.5 HMI lock
9.6 Turn-off delay for ground potential, safe outputs
Configuring the I/O ports
10.1 Setting module parameters for the safe input ports 0...3 and multi-function
ports 6 and 7
10.2 Enabling safe input 1 or 2
10.3 Enabling test pulses (TPO) for safe input 1 or 2
10.4 Turning off the test pulses
10.5 Sensor analysis (sensor evaluation)
10.6 Sensor valence (sensor behavior)
10.7 Discrepancy error correction
10.8 Discrepancy time (assuming 1oo2 sensor analysis)
10.9 Input delay
10.10 Special feature of multi-function ports (6 and 7)
10.11 Additional standard in- and outputs
10.12 Setting module parameters for safe output ports 4 and 5
10.13 Safe output enable/disable
10.14 Test pulses enable/disable
10.15 Read-back time
10.16 Module-internal test pulse generator
Connection examples
11.1 Connection examples for input ports
11.2 Connection examples for output ports
Linking PROFIsafe process data with program modules
12.1 Address ranges
12.2 Safe input address range
12.3 Safe output address range
12.4 Standard input address range
12.5 Standard output address range
Finishing projecting
13.1 Validation
13.2 Opening P-Tool using an F-PLC with TCI interface
13.3 Opening P-Tool using an F-PLC without TCI interface
13.4 Checking configuration consistency
13.5 Verifying checksum on the safe I/O module
Check lists for startup and projecting
14.1 Installation
14.2 Parameter configuration
14.3 Acceptance test
42
42
42
43
51
51
51
52
53
54
55
56
56
58
60
61
62
64
65
66
68
69
69
70
71
72
74
74
75
75
79
80
80
82
83
83
83
84
84
85
87
87
87
88
88
89
90