Balluff BNI IOF-329-P02-Z038 Betriebsanleitung Seite 143

BNI IOF-329-P02-Z038
Safe I/O Module, Safety over IO-Link
IP67 Module
5
Connection
Figure 12: M12 female insert, 8-pin, A-coded (US: Sensor supply, U/TPO: Voltage supply/test pulse, DI: Standard
input, F-DI: safe input, DO: Standard output)
Status LEDs for multi-function ports
The two associated LEDs indicate the status of one of the safe input signals per port.
Figure 13: Position of the LED for a multi-function port (Port 6 shown here)
All other LED states are described in Section Diagnostics starting page 91.
www.balluff.com
Pin Function
1 U2/TPO2 short-circuit protected,
configurable (
2 US short-circuit protected
3 F-DI1 (LED 0)
4 F-DI2 (LED 1)
5 DI3
1)
6 U1/TPO1 short-circuit protected,
configurable (
7 GND
8 DO1
1), 2)
The signals are not generated or evaluated for safety purposes.
1)
Bear in mind for your risk assessment and application design that this output is turned off
2)
when a fault occurs.
LED State
Yellow, flashing (2 Hz)
0 (Input signal 1)
Yellow
Yellow, flashing (2 Hz)
1 (Input signal 2)
Yellow
Notes:
– The state of the non-safe in- and outputs (DI3 - Pin 5 / DO1 - Pin 8) on the multi-
function ports is not indicated by LEDs.
– The input characteristic of the digital sensor inputs corresponds to Input Type 3 per
EN/IEC 61131-2.
– The total current of Pins 1, 2, 6 and 8 may not exceed 2 A.
– Use adapter plug BCC0K16 (see Accessories on page 110) to have the same pin
configuration on one of the 8-pin multi-function ports as on one of the 5-pin ports
(Ports 0-3).
/ )
/ )
Function
Input 1 is initialized.
There is a High signal at Input 1.
Input 2 is initialized.
There is a High signal at Input 2.
english
Description
+24 V
(≤ 200 mA)
+24 V
(≤ 500 mA)
Channel 1
Channel 2
+24 V
(≤ 200 mA)
0 V
+24 V
(≤ 2 A)
25