Turbo-V 6000 Controller Description - Agilent Technologies Turbo-V 6000 Bedienungshandbuch

Turbo-V 6000 Controller Description

The controller is available in two versions:
The controllers are provided with a front panel with an LCD
alphanumeric display to indicate the operating
conditions/parameters of the Turbo-V pump and a keyboard, and a
rear panel with input/output connectors. The following figure is a
picture of the Turbo-V controllers. The controller is a solid-state
frequency converter which is driven by a single chip microcomputer
and is composed of:
The power supply converts the single phase (50-60 Hz) AC mains
supply into a 3-phase, low voltage, medium frequency output which
is required to power the Turbo-V pump.The microcomputer generates
the variable output frequency and controls the 3-phase output
voltage according to the software and the gas load condition of the
pump.Moreover, it manages signals from sensors, input/output
connection information to be displayed, and gives outputs for a fully
automatic operation. An EEPROM internal to the microprocessor is
used to store pump operating parameters and the input/output
programmed information.
The controller can be operated via:
Turbo-V 6000 Controller User Manual / 87-900-855-01
Model 969-9491 (220 Vac, 50-60 Hz)
Model 969-9591 (120 Vac, 50-60 Hz)
Power transformer
Front panel display and keyboard
Rear panel with input/output connectors
Power PCB including: power supply and 3-phase output.
Control PCB including: analog and input/output section,
microprocessor and digital section.
Front panel switches
Remote signals via rear panel connectors
RS 232/422/485 serial link (option)
Technical Information

Turbo-V 6000 Controller Description

(F)
17
207/274