Agilent Technologies Turbo-V 6000 Bedienungshandbuch Seite 264

17 Technical Information
Monitor Relay Programming
A
If the Soft Start has been deselected the display shows:
P
where: LS = means low speed mode is selected.
After starting, a LS appears on the right bottom corner of the
following displays:
S
P
1
N
and when the pump reaches the low speed value, display reverts to
N
With normal LOW SPEED operation, the pump will run at about 2/3
(in any case not less than 9) of its nominal speed and achieves a base
pressure somewhat higher than the standard specifications. If the gas
load becomes higher, the controller output frequency and voltage
start to decrease automatically, and the Turbo-V pump is slowed
down in proportion to the gas load until it reaches about 0.7 KRPM.
If the LOW SPEED mode is selected after normal operating condition
is reached, the display shows:
264/274
P P R O A
X X . X
U M P R
S T A R
O F T S
[ - -
U M P
2 X X
O R M A
X X
O R M A
9
Turbo-V 6000 Controller User Manual / 87-900-855-01 (F)
C H I N
K R P
E A D Y
T B U
T A R
- - - -
I S S
K R P
L O P
K R P
L O P
0 K R P
G L S
M
: P U
T T O N
T O N
- - - -
T A R T
M
E R A T
M
E R A T
M
L S
S H
L S
] L S
I N G
L S
I O N
L S
I O N
L S