Turbo-V 700 Ice Controller Description - Agilent Technologies Turbo-V 700 ICE Bedienungshandbuch

Turbo-V 700 ICE Controller Description

The controller is available in two versions:
The models are provided with a front panel with an LCD
alphanumeric display to indicate the operating
conditions/parameters of the Turbo-V pump and a keyboard, and a
rear panel with input/output connectors. The following figure is a
picture of the Turbo-V controllers. The controller is a solid-state
frequency converter which is driven by a single chip microcomputer
and is composed of:
The microcomputer generates the variable output frequency and
controls the 3-phase output voltage according to the software and the
gas load condition of the pump. Moreover, it manages signals from
sensors, input/output connection information to be displayed, and
gives outputs for a fully automatic operation. The heater jacket and
flow meter are also handled.
An EEPROM internal to the microprocessor is used to store pump
operating parameters and the input/output programmed
information.
The controller can be operated via:
Turbo-V 700 ICE Controller User Manual / 87-900-904-01 (L)
Model 969-9446 (220 Vac, 50-60 Hz)
Model 969-9546 (120 Vac, 50-60 Hz)
Power transformer
Front panel display and keyboard
Rear panel with input/output connectors
PCB including: power supply analog and input/output section,
microprocessor and digital section, display and keyboard
circuits. The power supply converts the single phase
(50-60 Hz) AC mains supply into a 3-phase, low voltage, medium
frequency output which is required to power the Turbo-V pump.
Front panel switches
Remote signals via rear panel connectors
RS 232/485/422/485 serial link (option).
Technical Information

Turbo-V 700 ICE Controller Description

17
207/262