Connection P31 Turbo-V Pump Signals - Agilent Technologies Turbo-V 6000 Bedienungshandbuch

17 Technical Information
Connection P1 Logic Input Interconnections

Connection P31 Turbo-V Pump Signals

A cable is provided to connect the controller to the pump. If this
cable is not connected on both sides, the pump does not start. The
signal cable is shown in the following figure and has the following pin
configuration:
Figure 12
Figure 13
218/274
P31 connector
Signals cable
Turbo-V 6000 Controller User Manual / 87-900-855-01 (F)