Speed Adjustment - Agilent Technologies Turbo-V 6000 Bedienungshandbuch

17
Technical Information
Monitor Relay Programming
When PUMP LIFE is reset to 000, the CYCLE number is also reset to 000.
NOTE

Speed Adjustment

By pressing CYCLE NUMBER and PUMP CURRENT push button
together for at least five seconds the processor enters in a routine
where it is possible to adjust the rotational speed.
The display shows:
S P E E D A D J U S T
1 4 . 0 K R P M
Press the PUMP push button to select the digit to be changed and
when press the CYCLE push button to change the value.
The speed value can be changed from 9 to 14 KRPM. Different values
are rejected. The speed adjustment sets the LOW SPEED freq. to 2/3
in any case not less than 9.
Turbo-V 6000 Controller User Manual / 87-900-855-01 (F) 259/274