Agilent Technologies Turbo-V 6000 Bedienungshandbuch Seite 257

D
where: XXX = YES or NO.
This function is factory-set to YES.
D
Figure 41
Turbo-V 6000 Controller User Manual / 87-900-855-01
When the last digit is entered, the display shows:
E L A Y
T H R E
Press the CYCLE NUMBER push-button and select YES if relay
R2 must operate only after the run-up time or select NO when the
R2 operation is needed right from start of the turbopump and
after the rotational speed of the turbopump exceeds for the first
time the speed threshold value (see the preceding cycle diagram).
E L A Y
T H R E
Monitor Relay Programming
E V E N
S H O L D
E V E N
S H O L D
(F)
Technical Information
A F T
: X
A F T
: Y E
257/274
17
E R
X X
E R
S