Position Indicator - Truma Mover XT Gebrauchsanweisung

Mark connection pipe in the centre. Loosely attach the drive
assemblies to the connection pipe.
Do not screw in the supplied threaded bolts (g) yet.
Figure 23
Place the drive assemblies with the connection pipe and
mounting kit (b) on the vehicle frame and bolt them on with
the two bolts (c) in such a way that it is just possible to move
them along the frame.
The gripper (a) must be lying flat against the chassis
frame (e) in its entirety and also flat against the leg (d).
Figure 24
b
Figure 25
If the frame is not high enough, Truma can provide 30 mm
and 60 mm spacer sets as accessories in order to compen-
sate for this.
30 mm spacer set, part no. 60030-95000
60 mm spacer set, part no. 60030-95100
Make sure that there is adequate ground clearance (at least
110 mm).
Driving direction
Figure 26
g
d
e
c
a
b
Mover
min. 110 mm
Set the correct distance between tyres and rollers (20 mm)
with the spacer gauge provided by moving the drive assem-
blies (in the disengaged position) in the longitudinal direction.
The movable connection pipe makes it possible to adjust to
the frame width.
Driving direction
Figure 27
Move the drive assemblies in a lateral direction in such a way
that as much of the tread area of the tyre / drive roller as poss-
ible is covered.
Once the drive assemblies have been correctly positioned,
tighten the bolts (c) of the mounting set a little, then check the
required distances again. The weight of the caravan must be
resting on the wheels when doing this.
Place the movable connection pipe in the centre (use the mark-
ing) and fix each side with a threaded bolt (g) M8 x 12 (15 Nm).
The threaded bolts are coated with sealant, and must
therefore only be bolted in once.
Re-check the distance of 20 mm from the tyre (with the
wheels under load). Then tighten the 2 bolts of the mounting
set (M10) alternately to 25 Nm.
Figure 28
The bolts are coated with sealant, and must therefore
only be bolted in once.

Position indicator

Indicates how far the Mover® XT / XT2 is engaged.
No number visible: Disengaging position
Numbers 1 to 3 visible: Engaging position
Figure 29
20 mm
min. 110 mm
25 Nm
Mover
25