Function Check; Warnings - Truma Mover XT Gebrauchsanweisung

If necessary, insert socket connector back into socket housing (i).
Screw socket housing (i) with rubber seal (h) to socket
holder (g) using 3 sheet metal screws (j). (Several positions
are possible by selecting the mounting holes on the socket
holder and rotating the rubber seal)
Lead cable loosely through the strain relief (k) and screw in
place with the 2 sheet metal screws. Depending on the instal-
lation situation, the cable can be led out of the socket holder
through one of the three recesses.
g
PT 4 x 10
Figure 36
Secure safety socket to the (plastic) shaft cover of the caravan
with 4 screws, nuts and washers.
M4 x 16
(4 x)
Washer 4.3
(4 x)
Figure 37
No holes must be drilled in the chassis.
Alternatively, the safety socket can be secured using the two
clips.
Figure 38
Route both wires to the control unit (shortening them if necess-
ary) and connect them to the connector block as shown in the
connecting diagram.
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.
28
i
B 3.9 x 33
(3 x)
h
Nut M4 (4 x)

Function check

Check whether the battery is fully charged for operating the
Mover® XT / XT2.
Position the caravan on open, level ground and apply the
parking brake. The drive rollers must not be in contact with
the wheels and the corner jacks must be raised.
Connect the battery terminals to the battery. Check that all
cables are securely attached and not hot, and that there are
no signs of short circuits etc.
Plug the 13-pin plug / adapter into the safety socket.
Move slide switch on remote control to the "On" position.
This switches on the remote control, and green LED 4 flashes
until the control unit is ready for operation. If LED 4 does not
j
light up, check polarity and condition of batteries in remote
control.
Check that neither drive motor is running. With the remote
control switched on, operate the "slide control (C)". Both drive
motors must rotate.
k
Engage drive rollers using remote control.
Ensure that there are no obstacles around the caravan and re-
lease the parking brake. Now check all functions several times
in accordance with the operating instructions.
Apply caravan parking brake. Disengage drive rollers and
move remote control slide switch to "Off" £ in order to switch
off the remote control and the Mover® XT / XT2. Re-check dis-
tance between drive rollers and tyres. Re-adjust if necessary.
The distance between the disengaged drive rollers and
the tyres is 20 mm.

Warnings

The installer or vehicle owner must apply the yellow sticker
with the warning information, which is enclosed with the ap-
pliance, in a location in the vehicle where it is clearly visible
to all users (e.g. the wardrobe door). Missing stickers can be
requested from Truma.