Herunterladen Inhalt Inhalt Diese Seite drucken

Carina Professional Bedienungsanleitung Seite 41

Vorschau ausblenden Andere Handbücher für Professional:
Inhaltsverzeichnis

Werbung

Fil supérieur
Enfilage du fil supérieur
Enfilez le fil à travers le guide-fil de la droite vers la
gauche puis de l'arrière vers l'avant, comme illustré.
Placez le fil dans la fente de droite puis enfilez-le vers en
bas.
Passez le fil sous le guide-fil puis faites-le remonter.
Arrivé en haut, faites passer le fil de la droite vers la
gauche dans la fente du guide-fil métallique puis faites
le redescendre.
Faites glisser le fil derrière le guide-fil plat horizontal.
Placez l' e xtrémité du fil de l'avant vers la droite à travers
la petite tige située sur le support du pied de biche et
laissez dépasser une longueur de fil d' e nviron 10 cm.
Pour enfiler le fil dans l'aiguille utilisez l' e nfileur (voir page
suivante).
Upper Thread
Threading the upper thread
Guide the thread around the thread guide pulling the
thread through the pre-tension spring as illustrated.
Guide the thread into the right slot and pass it down-
wards.
Then, down and around the check spring holder and up
again.
At the top of this movement, pass the thread from right
to the left through the slotted eye of the take-up lever
and then downwards again.
Pass the thread behind the flat, horizontal thread guide.
Pull the end of the thread through the needle from
front to rear, and pull out about 10 cm of thread.
Use the needle threader to thread the needle. (On the next
page).
Bovendraad
Bovendraad inrijgen
Trek de draad naar links door de draadgeleider en
vervolgens naar voren, zoals afgebeeld.
Plaats de draad in de rechte sleuf en leid de draad om-
laag.
Naar links onder de geleidingspunt door en dan weer
naar boven leiden.
Eenmaal boven de draad van rechts naar links in de
gleuf van de metalen draadhevel leggen en weer omlaag
leiden.
Voer de draad achter langs de vlakke, horizontale
draadgeleiding.
Trek het uiteinde van de draad van voren naar achteren
door het oogje op de persvoethouder en laat een eindje
van ongeveer 10 cm over.
Gebruik voor het inrijgen van de naald de inrijger (zie de
volgende pagina).
41

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis