Commissioning The On-Board Computer With External Batteries; Display Settings - Torqeedo Cruise 10.0R TorqLink Originalbetriebsanleitung

Startup
6
5
4
3
Fig. 48: Overview of multifunction display
1
Battery charge state in percent
2 Remaining range at
current speed
3 Status notes (neutral position,
message log, charge symbol)
5.7.2 Commissioning the on-board computer with
external batteries
1. Press the Set-up button in order to access the Set-up menu.
2. Use the CAL button to select the information on battery configuration in the on-
board computer.
1
2
4
Current power consumption in
kilowatts
5 Speed in knots
6 Speed indicator
Select between Li for lithium or Pb for lead gel or AGM batteries.
3. Confirm your selection using the Set-up button.
4. Enter the size (in Ampere hours) of the battery bank connected to the motor.
5. Confirm your selection using the Set-up button.
Making this selection exits the Set-up menu.
A DVICE
Please note that two batteries connected in series, each of 12 Volt and 200 Ah,
have a combined capacity of 200 Ah (and not 400 Ah) at 24 Volt.
A DVICE
The displays of percent capacity and the remaining range are possible only after
set-up and the initial calibration have been completed, see Chapter 6.2.2, "Use
of the battery status display when using external batteries".
5.7.3

Display settings

In the Set-up menu, you can select the units to be displayed on screen. The notes for
this are available in the accelerator lever manual.
EN DE
page 85 / 113