Operation; Emergency Stop - Torqeedo Cruise 10.0R TorqLink Originalbetriebsanleitung

DE EN
6

Operation

W AR N IN G !
Danger to life from a boat which is not manoeuvrable!
This can result in severe physical injuries or death.
Before starting a trip, inform yourself of the intended travel area, and take
note of the predicted weather and water conditions.
Depending on the size of the boat, keep the typical safety equipment ready
(anchor, paddles, means of communication, auxiliary drive if necessary).
Check the system for mechanical damage before setting out on a trip.
Do not use the system unless it is in proper working order.
6.1

Emergency Stop

Danger to life if the Emergency Stop is not triggered!
Death or severe physical injuries may result.
Attach the cord on the Emergency Stop magnetic chip to the skipper's wrist
or to his life jacket.
A DVIC E
Test the functioning of the Emergency Stop switch at low motor power
before every trip.
In emergency situations, actuate the Emergency Stop immediately.
At high power, use the Emergency Stop only in emergency situations.
Repeated actuation of the Emergency Stop switch at high power stresses the
Cruise system, and can cause damage to the battery electronics.
page 86 / 113
D ANG ER !
There are various options for stopping the Cruise system rapidly:
Place the accelerator lever in the neutral position.
Pull off the Emergency Stop magnetic chip.
Place the battery main switch in the "OFF" or 0 position.
A DVICE
If the motor is stopped by means of the battery main switch during operation,
then this must be replaced immediately by a service partner.
A DVICE
If you have pulled out the Emergency Stop magnetic chip, you must first bring
the lever to the neutral position before continuing your trip. Then replace the
magnetic chip in position. After a few seconds you can continue your trip.
Operation